I am using the SE8C Signal Decoder from Digitrax on my layout
The wires I had strung were cables, not ribbon cable so I made this
converter board.  The idea was to solder wires to the card-edge tabs
and plug in the 10 pin IDC for the SE8C.   I abandoned the idea and ran
ribbon cable instead (what I should done at beginning)
Copyright ©2018 Queenidog - All Rights Reserved
The Digitrax Occupancy detector puts out a feeble 3 mA for LEDs,
not enough to light big LEDs and/or a remote panel that could be
some distance away, so I made this driver for it.